BLINKING AN LED WITH ARDUINO TINKERCAD

  To blink an LED ,we can use ARDUINO UNO, ARDUINO NANO boards.

It is the very basic and very basic program to execute.In this tutorial you can observe the code and the circuit diagram

First take the arduino uno board from the tinkercad website. And take a resistor from the components list.And  take a LED from the same components link.

CIRCUIT DIAGRAM FOR BLINKING AN LED WITH ARDUINO

1.Connect the LED anode pin to the ground pin of the Arduino Uno.

2.Connect the another end of LED to the 1k resistor and then to the 13th pin of the arduino.

3.Dump the codeand simulte now..

======>CODE FOR THE BLINKING LED WITH ARDUINO

 

//GET CODE HERE void setup{ pinMode(13, OUTPUT); } void loop { digitalWrite(13, HIGH); //LED TURNS ON delay(1000); //1 second digitalWrite(13, LOW); //LED TURNS OFF delay(1000); // 1 second }